[PLUG] fc3 conversion problem

["George Gallen" <ggallen@slackinc.com>]

I did an fc2 -> fc3 upgrade last night.
Everything seemed to go fine.

While it started to boot, my screen looked like a TV receiver that had no signal
  and the horizonal and verticle were stable as well.

Then the monitor clicked into another mode, the screen looked fine.

I logged in as root, went to open the start menu, and again, I got the no signal screen
   and it never came back.

I didn't have anymore time to play with this, so I shut it down. 

I'm hoping this is a just a 1 time thing.

Does this sound familiar? Of course, I can't go back now to fc2, so I may wind up
   having to do a fresh fc3 install if it doesn't fix itself.

The video was fine with fc2....

George

George Gallen
Senior Programmer/Analyst
Accounting/Data Division
ggallen@slackinc.com
ph:856.848.1000 Ext 220

SLACK Incorporated - An innovative information, education and management company
http://www.slackinc.com

___________________________________________________________________________
Philadelphia Linux Users Group         --        http://www.phillylinux.org
Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
General Discussion  --   http://lists.phillylinux.org/mailman/listinfo/plug