|
[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
|
Re: [PLUG] Xen 3.0.3 peth0 network issue
|
On Tue, Jan 27, 2009 at 2:43 PM, Tharun Kumar Allu
<tharun.allu@gmail.com> wrote:
> Hi,
> After installing xen 3.0.3 on the centos box I am unable to get the
> full network speed available.
> This is the dmesg related to peth0
>
> #dmesg| grep peth0
> ADDRCONF(NETDEV_UP): peth0: link is not ready
> bnx2: peth0 NIC Copper Link is Up, 100 Mbps half duplex
> ADDRCONF(NETDEV_CHANGE): peth0: link becomes ready
> device peth0 entered promiscuous mode
> xenbr0: port 2(peth0) entering forwarding state
>
> peth0 is up as 100M half duplex. How can I make this 1000M Full duplex ?
>
> did any one face similar issue?
Never mind. It was our network guys. The physical link was not set right.
Thanks
--
Tharun Kumar Allu
==============
___________________________________________________________________________
Philadelphia Linux Users Group -- http://www.phillylinux.org
Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug
|
|