|
[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
> Perhaps you could paste the output of dmesg, cat /proc/interrupts,
> and cat /proc/ioports while all three cards are configured?
cat ioports:
0000-001f : dma1
0020-003f : pic1
0040-005f : timer
0060-006f : keyboard
0080-008f : dma page reg
00a0-00bf : pic2
00c0-00df : dma2
00f0-00ff : fpu
0170-0177 : ide1
01f0-01f7 : ide0
0213-0213 : isapnp read
0280-029f : eth2
02f8-02ff : serial(auto)
0376-0376 : ide1
03c0-03df : vga+
03f6-03f6 : ide0
03f8-03ff : serial(auto)
0a79-0a79 : isapnp write
0cf8-0cff : PCI conf1
6000-60ff : Lite-On Communications Inc LNE100TX
6000-60ff : tulip
6100-61ff : National Semiconductor Corporation DP83815 (MacPhyter)
Ethernet Controller
6100-61ff : eth0
f000-f00f : Intel Corp. 82371SB PIIX3 IDE [Natoma/Triton II]
f000-f007 : ide0
f008-f00f : ide1
cat interupts:
CPU0
0: 65025 XT-PIC timer
1: 2617 XT-PIC keyboard
2: 0 XT-PIC cascade
5: 1 XT-PIC NE2000
9: 3401 XT-PIC eth0
10: 289 XT-PIC eth1
12: 6536 XT-PIC PS/2 Mouse
14: 7624 XT-PIC ide0
15: 4 XT-PIC ide1
NMI: 0
ERR: 0
dmesg is attatched
Thanks for the help, this is a clue, I see.
Fred
Linux version 2.4.16 (root@underwood) (gcc version 2.95.4 (Debian prerelease)) #1 Sun Feb 10 15:09:35 EST 2002
BIOS-provided physical RAM map:
BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
BIOS-e820: 0000000000100000 - 0000000008000000 (usable)
BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
On node 0 totalpages: 32768
zone(0): 4096 pages.
zone(1): 28672 pages.
zone(2): 0 pages.
Kernel command line: auto BOOT_IMAGE=linux16 ro root=307 hdb=ide-scsi,ether=0,0,eth1 ether=0,0,eth2,ether=0,0,eth3
ide_setup: hdb=ide-scsi,ether=0,0,eth1
Initializing CPU#0
Detected 199.311 MHz processor.
Console: colour VGA+ 80x25
Calibrating delay loop... 397.31 BogoMIPS
Memory: 126548k/131072k available (1236k kernel code, 4136k reserved, 404k data, 216k init, 0k highmem)
Dentry-cache hash table entries: 16384 (order: 5, 131072 bytes)
Inode-cache hash table entries: 8192 (order: 4, 65536 bytes)
Mount-cache hash table entries: 2048 (order: 2, 16384 bytes)
Buffer-cache hash table entries: 8192 (order: 3, 32768 bytes)
Page-cache hash table entries: 32768 (order: 5, 131072 bytes)
CPU: Before vendor init, caps: 000001bf 00000000 00000000, vendor = 0
Intel Pentium with F0 0F bug - workaround enabled.
CPU: After vendor init, caps: 000001bf 00000000 00000000 00000000
CPU: After generic, caps: 000001bf 00000000 00000000 00000000
CPU: Common caps: 000001bf 00000000 00000000 00000000
CPU: Intel Pentium 75 - 200 stepping 0c
Checking 'hlt' instruction... OK.
POSIX conformance testing by UNIFIX
PCI: PCI BIOS revision 2.10 entry at 0xfb0a0, last bus=0
PCI: Using configuration type 1
PCI: Probing PCI hardware
Limiting direct PCI/PCI transfers.
Activating ISA DMA hang workarounds.
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
VFS: Diskquotas version dquot_6.4.0 initialized
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
block: 128 slots per queue, batch=32
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
PIIX3: IDE controller on PCI bus 00 dev 39
PIIX3: chipset revision 0
PIIX3: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:pio, hdb:pio
ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:pio, hdd:pio
hda: Maxtor 91366U4, ATA DISK drive
hdd: 20X10, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: 26684784 sectors (13663 MB) w/2048KiB Cache, CHS=1661/255/63, (U)DMA
hdd: ATAPI 40X CD-ROM CD-R/RW drive, 2048kB Cache, DMA
Uniform CD-ROM driver Revision: 3.12
Partition check:
hda: hda1 hda2 < hda5 hda6 hda7 hda8 >
FDC 0 is a post-1991 82077
Linux agpgart interface v0.99 (c) Jeff Hartmann
agpgart: Maximum main memory to use for agp memory: 96M
agpgart: no supported devices found.
[drm] Initialized tdfx 1.0.0 20010216 on minor 0
[drm] Initialized radeon 1.1.1 20010405 on minor 1
SCSI subsystem driver Revision: 1.00
request_module[scsi_hostadapter]: Root fs not mounted
Linux Kernel Card Services 3.1.22
options: [pci] [cardbus] [pm]
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 1024 buckets, 8Kbytes
TCP: Hash tables configured (established 8192 bind 8192)
Linux IP multicast router 0.06 plus PIM-SM
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
ds: no socket drivers loaded!
VFS: Mounted root (ext2 filesystem) readonly.
Freeing unused kernel memory: 216k freed
Adding Swap: 72252k swap-space (priority -1)
ip_conntrack (1024 buckets, 8192 max)
Journalled Block Device driver loaded
CSLIP: code copyright 1989 Regents of the University of California
PPP generic driver version 2.4.1
natsemi.c:v1.07 1/9/2001 Written by Donald Becker <becker@scyld.com>
http://www.scyld.com/network/natsemi.html
(unofficial 2.4.x kernel port, version 1.07+LK1.0.13, Oct 19, 2001 Jeff Garzik, Tjeerd Mulder)
eth0: NatSemi DP8381[56] at 0xc8848000, 00:02:e3:1d:d9:7f, IRQ 9.
eth0: Transceiver status 0x7869 advertising 05e1.
Linux Tulip driver version 0.9.15-pre9 (Nov 6, 2001)
tulip0: MII transceiver #1 config 3000 status 7829 advertising 01e1.
eth1: Lite-On 82c168 PNIC rev 32 at 0x6000, 00:A0:CC:D0:76:37, IRQ 10.
isapnp: Scanning for PnP cards...
isapnp: Card 'PnP ISA Ethernet Adapter'
isapnp: 1 Plug & Play card detected total
ne.c: ISAPnP reports Generic PNP at i/o 0x280, irq 5.
ne.c:v1.10 9/23/94 Donald Becker (becker@scyld.com)
Last modified Nov 1, 2000 by Paul Gortmaker
NE*000 ethercard probe at 0x280: 00 80 ad 81 8b 19
eth2: NE2000 found at 0x280, using IRQ 5.
es1371: version v0.30 time 14:44:26 Feb 10 2002
scsi0 : SCSI host adapter emulation for IDE ATAPI devices
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.15, 06 Nov 2001 on ide0(3,5), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.15, 06 Nov 2001 on ide0(3,8), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
eth0: link is back. Enabling watchdog.
PPP BSD Compression module registered
PPP Deflate Compression module registered
device ppp0 entered promiscuous mode
eth1: Setting half-duplex based on MII#1 link partner capability of 40a1.
Sorry: masquerading timeouts set 5DAYS/2MINS/60SECS
|
|