| Stephen Gran on 5 Nov 2003 20:17:02 -0500 |
|
On Wed, Nov 05, 2003 at 06:33:50PM -0500, kaze said: > > From: plug-admin@lists.phillylinux.org > > [mailto:plug-admin@lists.phillylinux.org]On Behalf Of kaze > > > Uh, this NIC normally runs under the tulip family, if it's not > > > compiled into the kernel, it's often supplied as a module (insmod > > > tulip). Of course if your NIC is detected, then you might have to > > > give it a little help. For example what information does ifconfig > > > eth0 give? Unless > > > > Will supply this with the next post. > > > > > you're getting your IP address assigned by dhcp, you might have to > > > assign an IP address that fits within the range of whatever you're > > > trying to reach with the NIC. > > > > I'm using a static IP and triple checked that I have it configured > > right so I'm 95% sure that's not the issue. > > I pulled the 3COM NIC and put the LNE-100TX in, RH detected the new > hardware and allowed me to migrate settings. Here's what I get now, > it doesn't work yet... Of note is that lsmod shows tulip loaded. > > [root@sa root]# ifconfig eth0 > eth0 Link encap:Ethernet HWaddr 00:A0:FF:FF:9E:B6 > inet addr:10.10.10.50 Bcast:10.10.10.255 Mask:255.255.255.0 No gateway listed. What does route -n tell you? > [root@sa root]# ethtool eth0 > Settings for eth0: > No data available > [root@sa root]# mii-tool > no MII interfaces found > [root@sa root]# lsmod > Module Size Used by Not tainted > tulip 43840 1 > [root@sa root]# ping 10.10.10.50 > PING 10.10.10.50 (10.10.10.50) 56(84) bytes of data. > 64 bytes from 10.10.10.50: icmp_seq=1 ttl=64 time=0.066 ms > 64 bytes from 10.10.10.50: icmp_seq=2 ttl=64 time=0.054 ms > 64 bytes from 10.10.10.50: icmp_seq=3 ttl=64 time=0.064 ms > > --- 10.10.10.50 ping statistics --- > 3 packets transmitted, 3 received, 0% packet loss, time 1998ms > rtt min/avg/max/mdev = 0.054/0.061/0.066/0.008 ms > [root@sa root]# ping 10.10.10.211 > PING 10.10.10.211 (10.10.10.211) 56(84) bytes of data. > >From 10.10.10.50 icmp_seq=1 Destination Host Unreachable > >From 10.10.10.50 icmp_seq=2 Destination Host Unreachable > >From 10.10.10.50 icmp_seq=3 Destination Host Unreachable > --- 10.10.10.211 ping statistics --- > 5 packets transmitted, 0 received, +3 errors, 100% packet loss, time > 4088ms , pipe 3 > [root@sa root]# This might be routing problem. What does syslog say when the tulip module is loaded? It might also be a funky card. -- -------------------------------------------------------------------------- | Stephen Gran | BOFH excuse #74: You're out of memory | | steve@lobefin.net | | | http://www.lobefin.net/~steve | | -------------------------------------------------------------------------- Attachment:
pgpeinDCIRSLo.pgp
|
|