|
[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
|
Re: [Plug] Scsi setup problems
|
> Hey, I'm having a hell of a time figuring out this scsi problem. I=20
> upgraded warhammer to 2 (soon to be 3) seagate baracuda drives. If=20
> I cat /proc/scsi/aic7xxx/0 the hard drives are negotiaoting a 20m/sec
> transfer rate. How do you enable 40? I enabled it in the scsi bios.
>
> Also, in order to get the drives detected, I had to go into the scsi=20
> settings and change the termination from automatic to Low ON/High ON.
> Whats that all about? The drives are attached to an LVD cable, and=20
> have unique ID's set. Weirdness. I'm not overly familiar with SCSI stuff
> so I'm runing out of ideas.
>
M,
I have the same controller.
Have you enabled "enable wide negotiation = yes" in the scsi bios?
Good luck with the troubleshooting.
Chris
_______________________________________________
Plug maillist - Plug@lists.nothinbut.net
http://lists.nothinbut.net/mail/listinfo/plug
|
|