|
[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
|
RE: [PLUG] Multi-Processor Support -- Working
|
> In case anyone cares, once the install was completed everything seem to
> be fine. Found both CPU's just fine, and had installed an SMP kernel.
>
> The drives a still a little odd. I refused to replace the old partition
> table, but it would reuse the partitions already created. I couldn't
> find a way around it with any of the various tools I tried (from both
> the SuSE and KNOPPIX disks), but the old scheme wasn't too bad so I'm
> working with it. Only problem is that I couldn't setup a RAID, but
> it'll do.
Aaron,
Good to hear! Odd about the partition table. Is there something in
the bios that prevents partition table modification? You said it was a
server system, right? I've heard of such things, but never seen one
personally. What kind of disk controller are the drives on? (Make &
Model if you have it.) It's not a configurable scsi controller of some
kind, is it? Maybe it has external software to handle some setup
options. I use a Mylex RAID card that has config software on board,
plus has some external software for extra features.
--
Kevin
___________________________________________________________________________
Philadelphia Linux Users Group -- http://www.phillylinux.org
Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug
|
|