|
[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
|
Re: [PLUG] startx screwed up- rhel5- hp tft5600 kvm
|
Someone else may be able to give you instructions specific to rhel5,
but this should work on most fancy unixy systems upgraded from ye olde
x11r6 to xorg....
1) make a backup of your current xorg.conf. It's usually in /etc/X11/xorg.conf
2) then, run 'Xorg -configure'
3) pray
4) type startx again
-Jon
2009/3/19 Ron Kaye <rkaye2@csc.com>:
>
> never had to troubleshoot x
> dont know squat
>
> rhel 5 on hp dl360,connected to an hp tft5600 kvm
>
> at the command line, startx
>
> i get a graphic upper left, settings out of range,
> gui comes up, just cant read anything.
>
> i am guessing, there is an x11 conf file which i can edit to fix the
> problem?
> am i correct?
>
> figure a generic 1024x768 , 60MHz setting should suffice.
>
> i know the philly guys will know
>
> ron
>
> This is a PRIVATE message. If you are not the intended recipient, please
> delete without copying and kindly advise us by e-mail of the mistake in
> delivery.
> NOTE: Regardless of content, this e-mail shall not operate to bind CSC to
> any order or other contract unless pursuant to explicit written agreement or
> government initiative expressly permitting the use of e-mail for such
> purpose.
> ___________________________________________________________________________
> Philadelphia Linux Users Group -- http://www.phillylinux.org
> Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
> General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug
>
>
___________________________________________________________________________
Philadelphia Linux Users Group -- http://www.phillylinux.org
Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug
|
|