[PLUG] Xen 3.0.3 peth0 network issue

[Tharun Kumar Allu <tharun.allu@gmail.com>]

Hi,
After installing xen 3.0.3 on the centos box I am unable to get the
full network speed available.
This is the dmesg related to peth0

#dmesg| grep peth0
ADDRCONF(NETDEV_UP): peth0: link is not ready
bnx2: peth0 NIC Copper Link is Up, 100 Mbps half duplex
ADDRCONF(NETDEV_CHANGE): peth0: link becomes ready
device peth0 entered promiscuous mode
xenbr0: port 2(peth0) entering forwarding state

peth0 is up as 100M half duplex. How can I make this 1000M Full duplex ?

did any one face similar issue?

Thanks
Tharun
==============
___________________________________________________________________________
Philadelphia Linux Users Group         --        http://www.phillylinux.org
Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
General Discussion  --   http://lists.phillylinux.org/mailman/listinfo/plug