|
[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
|
RE: [Plug] Ethernet Interface won't start during RH 6.0 startup
|
Yes
It is set to start at boot-up.
Mark
-----Original Message-----
From: Martin DiViaio [mailto:martindiviaio@erols.com]
Sent: Wednesday, June 30, 1999 12:20 PM
To: plug@lists.nothinbut.net
Subject: Re: [Plug] Ethernet Interface won't start during RH 6.0 startup
"Ayares, Mark" wrote:
>
> I have a Toshiba Tecra 720CDT notebook on our internal NT network running
> Redhat 6.0. When I boot the machine and it runs through the loading of
> everything, the Ethernet Interface fails to load. Everything else comes
> back with an OK reply. When I go into X and look at the network setting,
> the Ethernet interface is not started. I am able to startup the Ethernet
> interface from X and it works fine. I am using a Xircom CEM56-10 100. I
> have checked out the Linux notebook websites, but have not found a
solution.
>
To ask a REALLY SILLY question: In netcfg do you have eth0 set to start
at boot?
If so then check /var/log/messages. Cardmgr will re-run your network
startup script at boottime. Sometimes the errors that stop the script
are posted there.
_______________________________________________
Plug maillist - Plug@lists.nothinbut.net
http://lists.nothinbut.net/mail/listinfo/plug
_______________________________________________
Plug maillist - Plug@lists.nothinbut.net
http://lists.nothinbut.net/mail/listinfo/plug
|
|