Michael C. Toren on 20 May 2004 01:09:03 -0000


[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]

Re: [PLUG] remember when you had a modem ...


On Tue, May 18, 2004 at 09:52:14PM -0400, Keith Bentrup wrote:
> i know caller id is working ... i run minicom, tell the modem AT#CID=1,
> and when a call comes in, there's the number!
> 
> if only i could either
> a) get the modem to remember the setting or

If your modem supports it, you can try sending the string "AT#CID=1" to set
the caller-ID status to the desired setting, then the string "AT&W" to write
out the current configuration to the modem's NVRAM.  This configuration will
then be restored whenever an "ATZ" reset is issued.

HTH,
-mct
___________________________________________________________________________
Philadelphia Linux Users Group         --        http://www.phillylinux.org
Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
General Discussion  --   http://lists.phillylinux.org/mailman/listinfo/plug