|
[Date Prev] [Date Next] [Thread Prev] [Thread Next] [Date Index] [Thread Index]
|
[PLUG] Debian Install with RAID problem
|
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Trying to Install Debian Sarge via net install (via CD) on a dell power
edge 6350. The power edge has a PERC2/SC raid controller in it, with 3
8.5 Gig drives. I have the raid controller setup to do mirroring on two
of the drives with one as a hot spare.
That *seems* to be set up correctly, formatted the disks, created the
array, set to RAID 1, and then initialized the logical device.
Rebooted, with the Debian cd. I then proceed to attempt to install
Debian, which works well until it tries to find the hard disk so it can
partition. It cannot.
I understand the perc2/sc uses the megaraid module, which I loaded by
hand after the attempt to partition failed. I then attempted this step
in the install again, no change. I tried various little things I found
online, nothing seems to work. I am sort of at a loss here as to what
to do next.
If anyone has any suggestions I would be happy to hear them. :)
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.4 (GNU/Linux)
iD8DBQFBx6bI3IzKSZsd6+oRAhUgAJ4o3glmpMnTa0ux9d56tHDbUvlHpwCeMjUY
AWKzntqz5auVTayVf8dfKXY=
=5pHZ
-----END PGP SIGNATURE-----
___________________________________________________________________________
Philadelphia Linux Users Group -- http://www.phillylinux.org
Announcements - http://lists.phillylinux.org/mailman/listinfo/plug-announce
General Discussion -- http://lists.phillylinux.org/mailman/listinfo/plug
|